0
this will be a problem :(.

i cut out the pin 4 track to test the reset/Vpp.
I tested the Vpp voltage.
I figure that the MC must enter programming mode although it is already programmed.
SN8P2722 Vpp = 12.3 V
S3F94x Vpp = 11.0 V

i put a 3k3 resistor on pin 4 and apply the voltage.
the MC dont start from 10,9 V to 11,5 V like a S3F94
  • avatar
  • taiteki
  • 20 сентября 2014, 14:24
0
hi, i am looking for a programmer that can support the S3F94x. And now an SN8P2722 too.

thx!
  • avatar
  • taiteki
  • 16 сентября 2014, 13:50
+1
sorry for reply in english.

i bought a yb27va Ver 1.5.

there are some changes in the shematic.


in other forum, some people helped me to find the MC i think is a zilog S3F94x.



thx for your information.
  • avatar
  • taiteki
  • 14 сентября 2014, 13:16